Caring for Your Hot Tub with Aqua Finesse & SpaGuard

Upon fill up:

1. Insert Proclear Cartridge into the filter with the grate underneath
2. Add 2oz of SpaGuard Chlorine directly to water
3. Check Ph with Test Strip
4. Adjust Ph as necessary with pH Increaser or pH Decreaser
5. Add Aqua Finesse as specified on bottle

After Each Use:

1. Add approximately ½ oz of chlorine directly to water per person

Weekly Maintenance:

1. Check Ph with Test Strip and adjust as necessary
2. Shock water with 2-4 oz Spa Shock
3. Add Aqua Finesse as specified on bottle

As needed:

1. If water is cloudy add 2 oz. of Spa Shock + 1 oz Chlorine or 2 oz Enhanced Shock if available

Monthly:

1. Apply Cover Care & Conditioner to cover to protect from UV rays
2. Check pH with Test Strip and adjust as necessary
3. Remove filters from the spa.  Rinse filters thoroughly and reinstall into spa.

Every 3-4 months:

1. Drain spa and wipe down shell with a cotton towel.  Once dry, apply a thin layer of Fast Gloss to the shell, allow 15 minutes to dry, and wipe off with a clean cotton towel.
2. Remove filters from the spa.  Dilute one bottle of Filter Clean in four gallons of water and allow filters to soak for at least three hours.  Rinse filters thoroughly and reinstall into spa.
3. Refill spa and refer to the Upon fill up portion above

Please Note:  If spa is not seeing regular use every 2-3 days please check and add sanitizer at LEAST twice a week. Also, for those looking to use the least amount of chlorine possible, you may substitute the use of chlorine after each use with 2 oz. of SpaShock per person per use. Then weekly, instead of adding spa shock, add 2 oz. of chlorine granules.